| ausmini https://www.ausmini.com/forums/ |
|
| Rover wiper motor wiring https://www.ausmini.com/forums/viewtopic.php?f=2&t=82220 |
Page 1 of 1 |
| Author: | drmini in aust [ Sat Jul 27, 2013 9:10 am ] |
| Post subject: | Rover wiper motor wiring |
I have a Rover? or UK Mini wiper motor here, it only has 3 wires- red, yellow and blue. It is marked RH park. I have tested it and it spins, can anyone tell me if this one is single speed, or 2 speed? Also, which wire goes where? Wiring diagrams don't seem to help, I have looked at early UK Mini, 1988 on UK, and MPI diagrams, all these motors have more wires and different colours. I am confused.... 
|
|
| Author: | winabbey [ Sat Jul 27, 2013 10:30 am ] |
| Post subject: | |
Does it have a part number? |
|
| Author: | drmini in aust [ Sat Jul 27, 2013 12:01 pm ] |
| Post subject: | |
winabbey wrote: Does it have a part number?
Yep... From the top- * 757391 14W PARK< 12V 4985 54072108. |
|
| Author: | MIN13R [ Sat Jul 27, 2013 12:34 pm ] |
| Post subject: | |
sent you an email for electrics and wiring 
|
|
| Author: | drmini in aust [ Sat Jul 27, 2013 2:06 pm ] |
| Post subject: | |
Thanks for that, but the late Rover motors shown on there have too many terminals.. this only has 3. |
|
| Author: | winabbey [ Sat Jul 27, 2013 2:18 pm ] |
| Post subject: | |
Doc, I don't have any parts books with that number, but a Google search on 54072108 and Lucas gives a few hits, including this forum that seems to have references to the wiring diagram. http://www.locostbuilders.co.uk/viewthr ... tid=139898 |
|
| Author: | drmini in aust [ Sat Jul 27, 2013 3:37 pm ] |
| Post subject: | |
On closer inspection it looks like perhaps this motor has lost its park switch. There is a rectangular hole on the back with nothing in it. That would account for it only having 3 wires... I have had it running off a 12V charger, but the 2 circuits both seem to give the same speed.
I have offered it free to a Rover owner on here for spare parts. 
I just need the shelf space. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|