| ausmini https://www.ausmini.com/forums/ |
|
| thrust bearing removal https://www.ausmini.com/forums/viewtopic.php?f=2&t=82227 |
Page 1 of 1 |
| Author: | IndigoBlueCooperS [ Sat Jul 27, 2013 9:46 pm ] |
| Post subject: | thrust bearing removal |
Is there a sound way to remove a good thrust bearing from a worn plunger shaft? The bearing is one of the originals, and the shaft is worn where the ball fits in. |
|
| Author: | Mick [ Sat Jul 27, 2013 10:08 pm ] |
| Post subject: | |
You would need to support the inner race as you press the plunger through. That would mean a lot of trouble as you would need to cut away the oversize outer end of the plunger and machine a hollow dolly to allow the plunger to be pressed through. Still not a guarantee however. |
|
| Author: | drmini in aust [ Sat Jul 27, 2013 10:39 pm ] |
| Post subject: | |
If all else fails you could probably press it off, don't use a BFH and punch for this, the impacts will bugger the balls/rollers and track. |
|
| Author: | simon k [ Mon Jul 29, 2013 9:44 am ] |
| Post subject: | |
I tried pressing one off once, f*cked it royally.... no way to get to the inner race on the outer side of it I'll have some of the good bearings to pass on this week though! |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|