| ausmini https://www.ausmini.com/forums/ |
|
| Missing compliance plate https://www.ausmini.com/forums/viewtopic.php?f=2&t=82895 |
Page 1 of 1 |
| Author: | paulc8712 [ Thu Sep 26, 2013 1:21 pm ] |
| Post subject: | Missing compliance plate |
Hi All. I have a 1971 Mini Clubman which I bought as a partial resto - but it is missing the compliance plate from the body (i can see where it use to be attached). The VIN etc are on the old rego label - and no doubt the VIN would also be on the chasis somewhere. What are my options in terms of either getting a replacement - or getting Vic Club plates without it? Thanks, Paul. |
|
| Author: | drmini in aust [ Thu Sep 26, 2013 1:56 pm ] |
| Post subject: | Re: Missing compliance plate |
The same numbers should still be be on the radiator shroud. As the car has been registered in Oz before it should not be a problem. As it is NOT a VIN plate, it is an ADR compliance plate. Standard 17 digit VIN plates started in 1980 (long after Oz Minis finished). |
|
| Author: | bnicho [ Thu Sep 26, 2013 2:07 pm ] |
| Post subject: | Re: Missing compliance plate |
A missing compliance plate is not a reason to fail an RWC in Vic. See here under "Identification (Compliance) Plates / VASS Approval Certificates" on P10. http://consult.vicroads.vic.gov.au/document/show/150 My Moke is a 71 and the compliance plate is missing too. Provided you have old rego papers or an old label so you can prove previous registration you will have no problems. Cheers, |
|
| Author: | womble99 [ Thu Sep 26, 2013 8:12 pm ] |
| Post subject: | Re: Missing compliance plate |
If you have the details why not buy a new plate? They are available on fleabay and other places. |
|
| Author: | bnicho [ Thu Sep 26, 2013 8:27 pm ] |
| Post subject: | Re: Missing compliance plate |
womble99 wrote: If you have the details why not buy a new plate? They are available on fleabay and other places. That is a build plate, not a compliance plate. Minis from 1970 had a compliance plate and nobody makes replicas. |
|
| Author: | Convertible Mini [ Fri Sep 27, 2013 7:00 am ] |
| Post subject: | Re: Missing compliance plate |
Time someone starts to make them then hey! |
|
| Author: | bnicho [ Fri Sep 27, 2013 8:08 am ] |
| Post subject: | Re: Missing compliance plate |
Convertible Mini wrote: Time someone starts to make them then hey! I think it might be naughty, because people could start creating their own Mini SS and 4 seater Californians! |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|