Hi all,

I've plonked the engine back into the car and got it all running nicely, but I went to go and tighten up the exhaust and found that I'd forgotten to put the lower exhaust mount back onto the gearbox. Problem is, I can't for the life of my figure out where it goes now! It probably doesn't help that when I took it off there was about an inch of oil and mud caked on...

Does anybody have any pics, or can you describe exactly how it mounts to the gearbox?

Does it go onto lower speedo housing bolt?

Bolts To the side of the gearbox, and you use the bolts that hold Your diff
side covers to the diff housing and the gearbox case

_________________
" A Hundred Years From Now It will not Matter what my Bank Acount Was,
The Sort Of House I Lived in, Or The Kind Of Car I drove ... But The World May Be A Better Place
Because I was Once Important In The Life Of A Child"

That's what I thought, but I can't see how the bolts line up, or the position it is supposed to be in. Is there more than one piece of the bracket?

Any of these pictures any help Irish ?
https://www.google.com.au/search?q=rod+ ... 11&bih=427

Cheers Bill

_________________
Project Pickles is ALIVE!!!!! Click Here!
Success is so much sweeter after the struggle

I've found this site:

http://www.moke.com.au/in-the-garage/re ... eplacement

Which has a few pictures - I can see some bolts missing where the exhaust has been moved to the side. I'll just need to get the bracket out again and play around a bit. I just couldn't position it anywhere where the bolts would line up last time.

http://www.classicmotoring.net.au/cmos/ ... ge&pID=566.
http://www.classicmotoring.net.au/cmos/ ... e&pID=1274
there the ones you need just put one on last week end with some mods to the bracket with a hack saw

http://www.minispares.com/product/Class ... |Back%20to

It bolts on with the diff cover