What is this and what does it do?
Thanks
| ausmini https://www.ausmini.com/forums/ |
|
| What is this for? https://www.ausmini.com/forums/viewtopic.php?f=2&t=83791 |
Page 1 of 1 |
| Author: | Morri68 [ Sun Dec 08, 2013 4:13 pm ] |
| Post subject: | What is this for? |
What is this and what does it do? Thanks |
|
| Author: | Mick [ Sun Dec 08, 2013 4:20 pm ] |
| Post subject: | Re: What is this for? |
It was used at the factory as a hold down onto their jigs. They are of no further use at our end. |
|
| Author: | Morri68 [ Sun Dec 08, 2013 4:44 pm ] |
| Post subject: | Re: What is this for? |
Hi Mick, so I can cut these off without affecting anything as they are all bent and mangled |
|
| Author: | Mick [ Sun Dec 08, 2013 5:00 pm ] |
| Post subject: | Re: What is this for? |
Yes, you can remove them if you wish. They're not a jacking point you are supposed to use at all either. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|