Anyone have a spare?
| ausmini https://www.ausmini.com/forums/ |
|
| so thats what was rattling... https://www.ausmini.com/forums/viewtopic.php?f=2&t=84103 |
Page 1 of 1 |
| Author: | mattsmadmini [ Mon Jan 06, 2014 3:41 pm ] |
| Post subject: | so thats what was rattling... |
Anyone have a spare?
|
|
| Author: | Mick [ Mon Jan 06, 2014 5:16 pm ] |
| Post subject: | Re: so thats what was rattling... |
Is that a 1275 one? Are they the same as 998 type? |
|
| Author: | justfanginaround [ Mon Jan 06, 2014 5:19 pm ] |
| Post subject: | Re: so thats what was rattling... |
998 and 1275 are different only in the hole placement, quick fix with a 5/16 drill bit  nice over flow bottle 
|
|
| Author: | Kennomini [ Mon Jan 06, 2014 5:37 pm ] |
| Post subject: | Re: so thats what was rattling... |
When you remove it check the bulkhead to make sure it's not cracked between holes as well. |
|
| Author: | leonrjohnson [ Mon Jan 06, 2014 5:40 pm ] |
| Post subject: | Re: so thats what was rattling... |
Check this out: MiniSport http://minisport.com.au/prod173.htm |
|
| Author: | aaron [ Mon Jan 06, 2014 6:49 pm ] |
| Post subject: | Re: so thats what was rattling... |
Pretty sure there is one here. Come get it. 
|
|
| Author: | John Smidt [ Mon Jan 06, 2014 7:21 pm ] |
| Post subject: | Re: so thats what was rattling... |
When You replace it Get an old brake pedal bracket, Minus the pedals cut the nose part off then bolt in place, this will Go a long way to stop the bulk head cracking, Also only use rubber bushes they ar a lot kinder to the bracket and the bulk head |
|
| Author: | mattsmadmini [ Mon Jan 06, 2014 10:59 pm ] |
| Post subject: | Re: so thats what was rattling... |
aaron wrote: Pretty sure there is one here. Come get it. Taking you up on that one. when is suitable? |
|
| Author: | aaron [ Tue Jan 07, 2014 10:54 pm ] |
| Post subject: | Re: so thats what was rattling... |
I'm around tomorrow. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|