Hey guys.

My new boot floor arrived yesterday so im out in the shed getting ready to put it in but seem to be having dramas getting it to fit.

Everything seems to line up but it just seems about 1-2mm to big on the edges.

Any one else had these dramas or is it just my mini?

_________________
The best part of fixing your mini is the test drive

Minis..

1976 van daily drive
1975 van
1968 deluxe in the shed
1967 deluxe high strung 1310
1959 austin healey sprite

My guess would be that they do this on purpose so that you have extra to play with. Not all minis are exactly the same as they were assembled pretty roughly.

_________________
Ryan Filippi
Minis In The Gong
[email protected]
www.minisinthegong.com.au

Yeah just a right pain in the a$$.

Will get it was just wondering if there was an issue with the body nit being square and straight. Have taken a few measurements and everything is square left to right.

_________________
The best part of fixing your mini is the test drive

Minis..

1976 van daily drive
1975 van
1968 deluxe in the shed
1967 deluxe high strung 1310
1959 austin healey sprite

That's standard on the 'new' panels, nothings right, designed NOT to fit. Next time you see a late Rover mini, have a look at the panel fit, absolutely woefull.

Cheers peter.. so I won't be doing anything wrong using the hammer to fit then..

_________________
The best part of fixing your mini is the test drive

Minis..

1976 van daily drive
1975 van
1968 deluxe in the shed
1967 deluxe high strung 1310
1959 austin healey sprite