| ausmini https://www.ausmini.com/forums/ |
|
| heritage replacement boot floor https://www.ausmini.com/forums/viewtopic.php?f=2&t=84463 |
Page 1 of 1 |
| Author: | boomini [ Wed Feb 05, 2014 6:26 pm ] |
| Post subject: | heritage replacement boot floor |
Hey guys. My new boot floor arrived yesterday so im out in the shed getting ready to put it in but seem to be having dramas getting it to fit. Everything seems to line up but it just seems about 1-2mm to big on the edges. Any one else had these dramas or is it just my mini? |
|
| Author: | ryan [ Wed Feb 05, 2014 6:37 pm ] |
| Post subject: | Re: heritage replacement boot floor |
My guess would be that they do this on purpose so that you have extra to play with. Not all minis are exactly the same as they were assembled pretty roughly. |
|
| Author: | boomini [ Wed Feb 05, 2014 6:40 pm ] |
| Post subject: | Re: heritage replacement boot floor |
Yeah just a right pain in the a$$. Will get it was just wondering if there was an issue with the body nit being square and straight. Have taken a few measurements and everything is square left to right. |
|
| Author: | peterb [ Wed Feb 05, 2014 8:14 pm ] |
| Post subject: | Re: heritage replacement boot floor |
That's standard on the 'new' panels, nothings right, designed NOT to fit. Next time you see a late Rover mini, have a look at the panel fit, absolutely woefull. |
|
| Author: | boomini [ Wed Feb 05, 2014 8:44 pm ] |
| Post subject: | Re: heritage replacement boot floor |
Cheers peter.. so I won't be doing anything wrong using the hammer to fit then.. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|