| ausmini https://www.ausmini.com/forums/ |
|
| dizzy advance https://www.ausmini.com/forums/viewtopic.php?f=2&t=84629 |
Page 1 of 1 |
| Author: | kiwiinwgtn [ Mon Feb 17, 2014 6:23 pm ] |
| Post subject: | dizzy advance |
I have been chasing a miss in my moke. Which was the coil. To my surprise the dizzy has a 18 degree cam. I believe its the original. So by my calc if I was to set up the dizzy to 10 degrees the over all timing would be 18x2+10=46 degrees plus the vacum advance mechanism has a futher 6 degree's so the total is 52 degress. Now for the question Why would the factory use such a high degree cam to start with. I have put in a dizzy with 10 degree weight and set the timing to 13 degrees giving this totals 33 degree's plus a little more for the advance. It pulls a heck of a lot better. Thanks Kiwiinwgtn |
|
| Author: | TheMiniMan [ Mon Feb 17, 2014 6:35 pm ] |
| Post subject: | Re: dizzy advance |
I think the most i`ve seen in factory dizzys is 15 |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|