| ausmini https://www.ausmini.com/forums/ |
|
| Driveshafts https://www.ausmini.com/forums/viewtopic.php?f=2&t=84800 |
Page 1 of 1 |
| Author: | Mr Miyagi [ Tue Mar 04, 2014 7:21 am ] |
| Post subject: | Driveshafts |
Howdy there folks. I have acquired 2 new bare pot joint driveshafts and noted the thick 2.30 mm washer on the inside of the CV joint spline is termed 'obsolete' by the suppliers. What is your advice here...Does one fit the old washers or leave them off? Many thanks in advance. M |
|
| Author: | Harley [ Tue Mar 04, 2014 8:11 am ] |
| Post subject: | Re: Driveshafts |
You can't leave it off - get some old ones then - better than none. I've swapped a few over before - PITA at times but straight forward. |
|
| Author: | mini_mad_matt [ Tue Mar 04, 2014 6:14 pm ] |
| Post subject: | Re: Driveshafts |
They stop the cv joint sliding onto the axle too far, combined with the circlip it keeps the joint secure in place. They aren't the easiest thing to swap over but it can be done. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|