I'd get a hammer and a long pin punch and thump it thru from inside the cabin. Probably outer's a bit rusty is all.
| ausmini https://www.ausmini.com/forums/ |
|
| replacing an accelerator cable https://www.ausmini.com/forums/viewtopic.php?f=2&t=849 |
Page 1 of 1 |
| Author: | F.U.B.A.R [ Tue Jun 15, 2004 1:18 pm ] |
| Post subject: | replacing an accelerator cable |
How do I get the accelerator cable out from where it goes into the firewall? I want to replace mine. |
|
| Author: | min13k [ Tue Jun 15, 2004 1:58 pm ] |
| Post subject: | |
it is like a bike brake cable at the top of the acellerator pedel remove it there then push through makka |
|
| Author: | F.U.B.A.R [ Tue Jun 15, 2004 2:21 pm ] |
| Post subject: | |
oh ok. I will have a look. thanks. |
|
| Author: | gafmo [ Tue Jun 15, 2004 3:22 pm ] |
| Post subject: | |
You may find it is easier if you release the cable first from the Carby and push it through. You will then see how it goes in. gafmo In the Hills |
|
| Author: | Anto [ Tue Jun 15, 2004 4:42 pm ] |
| Post subject: | |
Unless the outer housing of the cable is stuffed just replace the inner - much easier. Just unhook it from the pedal and pull the old inner cable through from the inside (can be tricky if the inner is very worn) and then push the new inner cable through. Too easy. Anto. |
|
| Author: | F.U.B.A.R [ Tue Jun 15, 2004 9:40 pm ] |
| Post subject: | |
the inner cable was rooted. I bought a new complete cable and couldn't get the old one out, so I yanked it out. It left part of it attached ot the firewall, thats why I was asking how to remove the dang thing. cheers for the info. |
|
| Author: | drmini in aust [ Tue Jun 15, 2004 10:24 pm ] |
| Post subject: | |
I'd get a hammer and a long pin punch and thump it thru from inside the cabin. Probably outer's a bit rusty is all.
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|