| ausmini https://www.ausmini.com/forums/ |
|
| flywheel to crank https://www.ausmini.com/forums/viewtopic.php?f=2&t=84976 |
Page 1 of 1 |
| Author: | boomini [ Sat Mar 22, 2014 10:41 am ] |
| Post subject: | flywheel to crank |
Hey guys how do you all fut your flywheels onto crank tapers? Dry or lubricated? Cheers guys |
|
| Author: | Minimadmarty [ Sat Mar 22, 2014 11:07 am ] |
| Post subject: | Re: flywheel to crank |
"Do not under any circumstances use grease, oil or any lubricating product on the taper of either part. You may however use Loctite 222# to act as a lubricant to assist the flywheel moving up the crankshaft taper. If using Loctite leave for 15 minutes before removing the nut and apply some 222# to nut and thread and retighten as before." Don't quote me Rodney I found this on another 'how to, forum! Sounds like you have a big day ahead of you! |
|
| Author: | Minimadmarty [ Sat Mar 22, 2014 11:12 am ] |
| Post subject: | Re: flywheel to crank |
Also found this: http://www.minimania.com/msgThread/111398/1/1/Flywheel_problems The forth comment suggest dry fitting! I'm the only one up this morning, not allowed to make noise and I'm bored! |
|
| Author: | boomini [ Sat Mar 22, 2014 11:24 am ] |
| Post subject: | Re: flywheel to crank |
Haha.. s I when it falls in a heap im blaming you marty..... I figured it was a dry fit but just thought I would ask. Cheers |
|
| Author: | Minimadmarty [ Sat Mar 22, 2014 11:31 am ] |
| Post subject: | Re: flywheel to crank |
My better half has always claimed I only have two faults; Everything I say & everything I do! So I wouldn't be taking my word for it Ha ha.... |
|
| Author: | boomini [ Sat Mar 22, 2014 11:33 am ] |
| Post subject: | Re: flywheel to crank |
Lol |
|
| Author: | simon k [ Sat Mar 22, 2014 5:28 pm ] |
| Post subject: | Re: flywheel to crank |
When I rebuilt my motor last year, I put some STP on the crank taper and then put the flywheel on.... the motor was still on the bench in January, and I wanted to take the flywheel off again in January. it ... would ... not ... budge my puller is 3/4" thick, and it had about 2mm of bend across the face of it from the amount of tension that was on it. I bashed, heated, bashed, heated, left it for a week, then gave up and left it on there use a bit of fine valve lapping paste and lap them to each other, then make them really clean and put them together dry |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|