| ausmini https://www.ausmini.com/forums/ |
|
| Pushrods https://www.ausmini.com/forums/viewtopic.php?f=2&t=85115 |
Page 1 of 1 |
| Author: | carter [ Wed Apr 02, 2014 3:18 pm ] |
| Post subject: | Pushrods |
Just wandering if there's any difference in 1275 pushrods compared to small bore push rods? If so can you put 1275 push rods in a small bore or a mixture or is this a no go? Thanks fellas |
|
| Author: | Mick [ Wed Apr 02, 2014 4:07 pm ] |
| Post subject: | Re: Pushrods |
The 1275 pushrods are about 1/4 of an inch taller to suit the taller block. |
|
| Author: | carter [ Wed Apr 02, 2014 4:43 pm ] |
| Post subject: | Re: Pushrods |
Ok thanks mick. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|