| ausmini https://www.ausmini.com/forums/ |
|
| 4 synchro layshaft https://www.ausmini.com/forums/viewtopic.php?f=2&t=85547 |
Page 1 of 1 |
| Author: | guna mk1 [ Sat May 03, 2014 8:50 pm ] |
| Post subject: | 4 synchro layshaft |
Hi all I am after a good quality Australian made hard , straight 4 synchro layshaft Any ideas on who can supply at a fair price ? Thanks |
|
| Author: | simon k [ Sat May 03, 2014 8:57 pm ] |
| Post subject: | Re: 4 synchro layshaft |
I believe Heritage MG have them made in Australia, but the one I got from them didn't last as well as the Minispares ones I've been using the last few years |
|
| Author: | 69k1100 [ Sat May 03, 2014 9:07 pm ] |
| Post subject: | Re: 4 synchro layshaft |
What's a decent price? Mini sport (south rd) has some, not sure if they're Australian steel. Secondhand ones are all worn in some aspect due to the loading on the layshaft. They're not terribly complicated so one could be made, doubt it would cost you too much but would still be more expensive than a regular production one, and there's a chance it would bend like a banana when it's heat treated. http://minisport.com.au/mini-layshaft-s ... rade-steel |
|
| Author: | drmini in aust [ Sat May 03, 2014 10:34 pm ] |
| Post subject: | Re: 4 synchro layshaft |
John Smidt was getting them made and heat treated here, not sure if he's still got stock. Karcraft supplied UK made ones I tested last year were over HRC61 hardness and they fit fine. I used the Heritage MG ones in my 2 gearboxes and they are still OK. |
|
| Author: | TK [ Sun May 04, 2014 11:19 am ] |
| Post subject: | Re: 4 synchro layshaft |
Yeah bent like a banana. LOL I got one a couple of years ago from M1n1spares. It was bent like a banana and took over six months to get a replacement. The Doc knows where to buy if you can't get NOS. |
|
| Author: | John Smidt [ Sun May 04, 2014 10:32 pm ] |
| Post subject: | Re: 4 synchro layshaft |
drmini in aust wrote: John Smidt was getting them made and heat treated here, not sure if he's still got stock. Karcraft supplied UK made ones I tested last year were over HRC61 hardness and they fit fine. I used the Heritage MG ones in my 2 gearboxes and they are still OK. Thanks Doc, Yes I have some good ones made in Australia ones I have had no problems with them at all |
|
| Author: | guna mk1 [ Mon May 05, 2014 7:05 pm ] |
| Post subject: | Re: 4 synchro layshaft |
All sorted Thanks everyone |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|