ausmini https://www.ausmini.com/forums/ |
|
Dumb Question of the Day https://www.ausmini.com/forums/viewtopic.php?f=2&t=85862 |
Page 1 of 1 |
Author: | BKozan [ Thu May 29, 2014 2:39 pm ] |
Post subject: | Dumb Question of the Day |
No nuts, bolts, screws or nails. Can't see any clips, grommets, latches, jubilees or clamps. I've pulled pretty hard, but maybe I need to pull harder. So how in the hell do I remove the Handbrake Handle from my '98 Rover? |
Author: | Harley [ Thu May 29, 2014 2:42 pm ] |
Post subject: | Re: Dumb Question of the Day |
It's just pushed on, but because its rubberised its hard to remove. Ive seen the odd one glued on too - not sure if that was factory or not though. |
Author: | Convertible Mini [ Thu May 29, 2014 3:06 pm ] |
Post subject: | Re: Dumb Question of the Day |
Try warming it up with a heat gun to make it release a bit. They are fitted tight. |
Author: | BKozan [ Thu May 29, 2014 3:13 pm ] |
Post subject: | Re: Dumb Question of the Day |
Thanks guys. I think I'll buy a proper heat gun on the way home. The Missus' hair dryer just isn't cutting it these days. |
Author: | Harley [ Thu May 29, 2014 3:20 pm ] |
Post subject: | Re: Dumb Question of the Day |
Try twisting it - that often helps. |
Author: | gtogreen1969 [ Thu May 29, 2014 4:34 pm ] |
Post subject: | Re: Dumb Question of the Day |
You need to stick your tongue out just a little. A filter strap can help break the seal. |
Author: | taztiger4 [ Thu May 29, 2014 4:40 pm ] |
Post subject: | Re: Dumb Question of the Day |
gtogreen1969 wrote: You need to stick your tongue out just a little. A filter strap can help break the seal. If its rubber, try peeling up a bit and squirting air thru a small nozzle up it !! Works for motorcycle hand grips |
Author: | BKozan [ Mon Jun 02, 2014 11:52 am ] |
Post subject: | Re: Dumb Question of the Day |
Yep, mine was glued on. After some prying, heating and clever use of fencing wire I managed to slide it off. I installed my fly-away handbrake and had some fun on a rainy Sunday in an empty carpark. I also found out that my cable needs some adjusting, as the passenger side didn't want to lock quite as nicely as the driver side. Good times. ![]() |
Page 1 of 1 | All times are UTC + 10 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |