Hi all,
These washers (for want of a better word) go on the top arm but which goes at the front?
| ausmini https://www.ausmini.com/forums/ |
|
| Subframe rebuild: Top arm parts https://www.ausmini.com/forums/viewtopic.php?f=2&t=86548 |
Page 1 of 1 |
| Author: | jubblies [ Sun Jul 20, 2014 8:38 pm ] |
| Post subject: | Subframe rebuild: Top arm parts |
Hi all, These washers (for want of a better word) go on the top arm but which goes at the front?
|
|
| Author: | Scoop [ Sun Jul 20, 2014 9:00 pm ] |
| Post subject: | Re: Subframe rebuild: Top arm parts |
I think the thick one is the front one, that has the retaining plate. |
|
| Author: | Mick [ Sun Jul 20, 2014 9:17 pm ] |
| Post subject: | Re: Subframe rebuild: Top arm parts |
+1 |
|
| Author: | BKozan [ Sun Jul 20, 2014 9:23 pm ] |
| Post subject: | Re: Subframe rebuild: Top arm parts |
Scoop wrote: I think the thick one is the front one, that has the retaining plate. Agreed. |
|
| Author: | jubblies [ Sun Jul 20, 2014 9:39 pm ] |
| Post subject: | Re: Subframe rebuild: Top arm parts |
That's unanimous. That's good enough for me! Thanks all. |
|
| Author: | boomini [ Sun Jul 20, 2014 11:32 pm ] |
| Post subject: | Re: Subframe rebuild: Top arm parts |
One will be bigger than the other match them up against the top arm. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|