| ausmini https://www.ausmini.com/forums/ |
|
| Morris Mini Deluxe Boot Badge holes https://www.ausmini.com/forums/viewtopic.php?f=2&t=86657 |
Page 1 of 1 |
| Author: | Morri68 [ Sat Jul 26, 2014 7:53 pm ] |
| Post subject: | Morris Mini Deluxe Boot Badge holes |
Hi all does any one know what the easiest way to drill the holes in the boot lid and getting them looking the same as it would of looked originally i do have the original boot lid and badges. Cheers Hayden |
|
| Author: | clr60 [ Sun Jul 27, 2014 3:25 pm ] |
| Post subject: | Re: Morris Mini Deluxe Boot Badge holes |
If you have the original boot lid use a piece of heavy thick paper, place the paper over the holes ensuring the top edge of the paper is level with boot lid edge , centred, mark the holes, transfer to new boot lid. Using masking tape stuck to boot lid mark the holes, drill a pilot hole remeasure again and complete the job. Regards |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|