ausmini
https://www.ausmini.com/forums/

Cooper S bonnet badging spacing/placement?
https://www.ausmini.com/forums/viewtopic.php?f=2&t=86700		 Page 1 of 1
Author:  MINImal effort [ Wed Jul 30, 2014 8:50 pm ]
Post subject:  Re: Cooper S badging spacing/placement?
Thought there was a "sticky" for this sort of thing .. but apparently not.

Lots of discussion on the boot lid location: http://www.ausmini.com/forums/viewtopic.php?f=2&t=38758
but not bonnet.
Author:  sitnlo62 [ Thu Jul 31, 2014 10:57 am ]
Post subject:  Re: Cooper S bonnet badging spacing/placement?
TweedGrey wrote:
So I popped in to see the little fella today (he's nearly finished and will be back on the bitumen and dodging potholes soon) and I've noticed the body shop have filled in the holes where the little 'S' should be on the bonnet. They've not put it back on. So... any idea where exactly it should go? How many millimetres from the top of the Cooper badge to the bottom of the 'S'??

I'd rather not guess - even though this is just a replica I'm making from my re-shelled Deluxe.

Cheers!

Scotty


3mm
Dave
Author:  Mick [ Thu Jul 31, 2014 11:00 am ]
Post subject:  Re: Cooper S bonnet badging spacing/placement?
I went to draw one up till I realised I have a Mk2 badged bonnet... :roll:
Author:  sitnlo62 [ Thu Jul 31, 2014 4:07 pm ]
Post subject:  Re: Cooper S bonnet badging spacing/placement?
TweedGrey wrote:
How many millimetres from the top of the Cooper badge to the bottom of the 'S'??


Scotty


Scotty,
The measurement from the top of the front Morris Cooper Badge to the Bottom of the small "S"
is 3mm.
If it was 3 cm the S would be sitting on top of the bonnet.........
Dave

Image
Author:  phillb [ Fri Aug 01, 2014 6:22 am ]
Post subject:  Re: Cooper S bonnet badging spacing/placement?
3mm sounds right. Many cars have them fitted too high. Look at old photos in magazines of when the cars were new and you'll see its close.
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/