Hi all,

Is there anywhere I can get the rear floor pan LH and RH from for an Australian Clubman? I can only find the UK ones that the pressing doesn't line up.

Any help would be much appreciated

_________________
Cheers

Dave

No one at this stage makes them best bet is to get one out of another car or try and get a sheety to make one

I used 2 front aussie pressings and performed a little cut and shut job. The only things, I had to remould the ends of the swages in the rear and shift the rear 2 of the mounting holes for the pipe cover plates.

Came out quite well if I do say so myself.

_________________
Current 1970 Mini K - full resto happening - finished and on the road since 10/2020
2001 Falcon AUII XL 1 Tonne styleside ute

Mini History
1963 - 850 - wish I still had it
1965 - 850 - was an unfinished project, gone
1972 - Clubbie

I have a rear uk floor pressing but will attempt to section it lengthways to line up the flutes, then weld it all back together.

I would try Cooper S Imports in Victoria. From memory he had some on display at Watto's Grand Day Out.
They included the front and rear in one pressing.

Pm sent

_________________
The best part of fixing your mini is the test drive

Minis..

1976 van daily drive
1975 van
1968 deluxe in the shed
1967 deluxe high strung 1310
1959 austin healey sprite