ausmini https://www.ausmini.com/forums/ |
|
Help identifying this panelvan https://www.ausmini.com/forums/viewtopic.php?f=2&t=87369 |
Page 1 of 1 |
Author: | waznotme [ Thu Oct 02, 2014 8:47 pm ] |
Post subject: | Help identifying this panelvan |
Hi, could I get some info on this round nose panelvan from the build plate? |
Author: | womble99 [ Thu Oct 02, 2014 8:59 pm ] |
Post subject: | Re: Help identifying this panelvan |
You have cut the top off but from the engine number it could possibly be a K Van? This site http://www.mini.org.au/mini_identification.html lists that engine prefix as belonging to a 1100 Mini K Van. |
Author: | waznotme [ Thu Oct 02, 2014 9:05 pm ] |
Post subject: | Re: Help identifying this panelvan |
I'll get another pic |
Author: | Scoop [ Thu Oct 02, 2014 9:07 pm ] |
Post subject: | Re: Help identifying this panelvan |
Mini K would be a good start being round nose and 1098. Brains trust could probably help more with the numbers side of things. |
Author: | waznotme [ Thu Oct 02, 2014 9:37 pm ] |
Post subject: | Re: Help identifying this panelvan |
Is it normal for the id plates for that era to be this scratched and messed up? Would there be any issues getting it registered? |
Author: | goodie [ Thu Oct 02, 2014 10:11 pm ] |
Post subject: | Re: Help identifying this panelvan |
Get a stiff bristled toothbrush & some WD40 and give the plate a bit of a scrub , see how it comes up . |
Author: | Morris 1100 [ Fri Oct 03, 2014 5:43 am ] |
Post subject: | Re: Help identifying this panelvan |
I think it is a 1969 Mini K van (Morris Mini 1100 Van). The ID plate will probably say.. Quote: Model = Mini Van Type = YJBAV4R Serial Number = ? (somewhere around the 3800 mark I would guess) Engine Number = 10YJUH 4233 Colour = 1/Cadet Blue/1 GVW = 2044lbs There is no problem with a scratched ID plate. There is no legal requirement for them except commercial vehicles must have a GVW weight which is why vans had ID plates in 69 when the sedans didn't. |
Author: | phillb [ Fri Oct 03, 2014 9:15 am ] |
Post subject: | Re: Help identifying this panelvan |
waznotme wrote: Is it normal for the id plates for that era to be this scratched and messed up? Would there be any issues getting it registered? Unfortunatly this happens often when there is a brake fluid spill, a few wipes and the paint is gone from the plate, the lower section of my ID plate is like this. As stated not a requirement for rego, but they should/will be more interested in the stampings in the actual body (which should match the number on the plate) |
Author: | waznotme [ Mon Oct 06, 2014 8:02 pm ] |
Post subject: | Re: Help identifying this panelvan |
Here's a better picture. |
Page 1 of 1 | All times are UTC + 10 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |