| ausmini https://www.ausmini.com/forums/ |
|
| Cooper S Diff Side Plate Seals https://www.ausmini.com/forums/viewtopic.php?f=2&t=87755 |
Page 1 of 1 |
| Author: | IndigoBlueCooperS [ Sat Nov 15, 2014 8:58 pm ] |
| Post subject: | Cooper S Diff Side Plate Seals |
What is the difference between the standard and Cooper S diff side plate? I know the ID is larger on the S, But is the OD for the seal the same or also larger? Can you modify a standard side plate to fit the S? (S being Hardy Splicer Joints) Thanks in advance. |
|
| Author: | Scoop [ Sat Nov 15, 2014 9:32 pm ] |
| Post subject: | Re: Cooper S Diff Side Plate Seals |
I thinks the o/d of the seal is slightly large. 47.3mm o/d normal and 50mm o/d for the S type. Thats what I found looking on the web anyway. |
|
| Author: | TK [ Sat Nov 15, 2014 9:50 pm ] |
| Post subject: | Re: Cooper S Diff Side Plate Seals |
some later Moke side plates can be modded (bored) but I just use Morris 1500 side covers with a minor mod (skim). |
|
| Author: | drmini in aust [ Sat Nov 15, 2014 11:03 pm ] |
| Post subject: | Re: Cooper S Diff Side Plate Seals |
The S seal is 1/8" bigger on OD and ID. So is the bronze bush, and it's 5 times dearer than a Mini one. So you have to bore the cover for both. And then fit & bore the bush, as they are supplied ~.007" undersize. The side covers to bore out are the ones with a machined ring on the outer corner, where a shroud was fitted. I think Mini K and early Clubby had these, as well as the Mokes. They have no part number on them... These covers have more meat around the bush than the early ones. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|