| ausmini https://www.ausmini.com/forums/ |
|
| Cutting panel metel in tight places https://www.ausmini.com/forums/viewtopic.php?f=2&t=87796 |
Page 1 of 1 |
| Author: | Darrell [ Wed Nov 19, 2014 5:55 pm ] |
| Post subject: | Cutting panel metel in tight places |
Cutting panels where the usual grinder cutting wheel is too big, what do people use, would something like a Dremel be ok or is there something better these days. |
|
| Author: | Kennomini [ Wed Nov 19, 2014 5:59 pm ] |
| Post subject: | Re: Cutting panel metel in tight places |
Air hacksaw. |
|
| Author: | drmini in aust [ Wed Nov 19, 2014 6:07 pm ] |
| Post subject: | Re: Cutting panel metel in tight places |
Hand nibbler, or an air one. |
|
| Author: | boomini [ Wed Nov 19, 2014 7:17 pm ] |
| Post subject: | Re: Cutting panel metel in tight places |
I got an air hacksaw and a 2" air cut of saw. Get too most places. Sometimes have too cut further or into another panel but the welder fixes that. |
|
| Author: | Scoop [ Wed Nov 19, 2014 7:23 pm ] |
| Post subject: | Re: Cutting panel metel in tight places |
I use snips a bit also. Cut the bulk of it with grinder and clean it up with die grinder and carbide burr. |
|
| Author: | awdmoke [ Thu Nov 20, 2014 9:10 am ] |
| Post subject: | Re: Cutting panel metel in tight places |
Plasma cutter. |
|
| Author: | Harley [ Thu Nov 20, 2014 9:13 am ] |
| Post subject: | Re: Cutting panel metel in tight places |
I have a reciprocating saw thats pretty handy and have resorted to a dremel for really tight stuff before. It all gets the job done.....just depends how fast you wanna do it. |
|
| Author: | Darrell [ Thu Nov 20, 2014 12:47 pm ] |
| Post subject: | Re: Cutting panel metel in tight places |
Thanks Guys have purchased some suggested tools Time is on my side well hopefully. |
|
| Author: | Diesel27 [ Thu Nov 20, 2014 3:46 pm ] |
| Post subject: | Re: Cutting panel metel in tight places |
I have found in the past a larger grinder wheel can reach hard to get places where the smaller grinder bodies foul A pneumatic dyna file can be useful as well. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|