ausmini
https://www.ausmini.com/forums/

Moke Front Subframe pictures
https://www.ausmini.com/forums/viewtopic.php?f=2&t=87982
Page 1 of 1

Author:  aaron [ Wed Dec 10, 2014 6:34 pm ]
Post subject:  Moke Front Subframe pictures

Hey all, I am rebuilding a moke and need some assistance as to what the lower rear subframe mount points look like. They are different to a mini in that there is a step (well on mine there is.) on the rear most bolt. i.e. the one on the flat floor. What I would like to see is the top(i.e. in the tub) bolt hole. (i'm guessing there is a plug covering it) and underneath to see how the bottom section is built. A couple on angles would be grand. Don't blame me if you find scary things under there. Mine wasn't scary, it just never existed so until i see what it is supposed to look like, i don't quite know what to fabricate.

Cheers
Aaron

Author:  Babes [ Wed Dec 10, 2014 7:25 pm ]
Post subject:  Re: Moke Front Subframe pictures

This is an 81 cali, not sure if they are any good to you. Still on the hoist so can take more if you need.

Image

Image

Image

Image

Image

Author:  aaron [ Wed Dec 10, 2014 8:06 pm ]
Post subject:  Re: Moke Front Subframe pictures

Thanks Babes. Those pics explain it all.

I don't know what they were thinking with that channel, no wonder the damn thing rusted out on every single one of them. My new version will come complete with proper drainage. And Galvanised! It might not look pretty, but it'll be strong.


Cheers
Aaron

Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/