| ausmini https://www.ausmini.com/forums/ |
|
| Lenthening pushrods for Elder head https://www.ausmini.com/forums/viewtopic.php?f=2&t=88159 |
Page 1 of 1 |
| Author: | Ian_B [ Tue Dec 30, 2014 6:27 pm ] |
| Post subject: | Lenthening pushrods for Elder head |
Me thinks get two sets of pushrods Cut em both turn one down to suit a drilling on the other and Loctite 601 to avoid welding distortions .Ideas Im an electronics tech lol |
|
| Author: | peterb [ Tue Dec 30, 2014 6:47 pm ] |
| Post subject: | Re: Lenthening pushrods for Elder head |
You can buy 3 piece ones from MSUK |
|
| Author: | Kennomini [ Tue Dec 30, 2014 6:48 pm ] |
| Post subject: | Re: Lenthening pushrods for Elder head |
Can you thread both ends of the cut down pushrods and use a threaded joiner sleeve and some locking nuts to set the lengths, How do they make the commercial adjustable ones? |
|
| Author: | Ian_B [ Tue Dec 30, 2014 6:52 pm ] |
| Post subject: | Re: Lenthening pushrods for Elder head |
Yep that sounds an option but the msuk may be easiest .Adjustible is good to allow for cam grind etc |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|