| ausmini https://www.ausmini.com/forums/ |
|
| flywheel machining https://www.ausmini.com/forums/viewtopic.php?f=2&t=88847 |
Page 1 of 1 |
| Author: | Diesel27 [ Wed Mar 11, 2015 7:58 pm ] |
| Post subject: | flywheel machining |
I am going to machine my flywheel in aid of lightening it some, can anyone please help with a bit of a not what to do if you can? also wondering if any other mods are required? I believe some spacers will be required in the clutch pressure plate? cheers |
|
| Author: | Scoop [ Wed Mar 11, 2015 8:29 pm ] |
| Post subject: | Re: flywheel machining |
I was going to do the same in a few weeks. Was going to base it on a thread I found from a while ago. viewtopic.php?f=2&t=83379&hilit=lightening+flywheel |
|
| Author: | Diesel27 [ Wed Mar 11, 2015 8:33 pm ] |
| Post subject: | Re: flywheel machining |
cheers Scoop, I did a search but got lost in the posts and couldnt find anything solid. |
|
| Author: | i got a mini [ Thu Mar 12, 2015 1:50 pm ] |
| Post subject: | Re: flywheel machining |
Take note off what you machine off the flywheel, because you will have to make spacers up for the bolts so they are at the right height. |
|
| Author: | Aussie Brian [ Thu Mar 12, 2015 3:45 pm ] |
| Post subject: | Re: flywheel machining |
I remember someone saying take 200 thousands of an inch off and no more. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|