ausmini https://www.ausmini.com/forums/
Fitting pins into roller bearing https://www.ausmini.com/forums/viewtopic.php?f=2&t=89099	Page 1 of 1

---

Author:	anza [ Wed Apr 08, 2015 11:25 am ]
Post subject:	Fitting pins into roller bearing
Hi all, I have removed my rear radius arms to clean and check. While cleaning on one arm all the pins fell out of the needle roller bearing. I am having a lot of issues refitting them. The casing all seems OK. Is there a easy/trick to refit the pins back in? The last pin is very hard to insert. Thanks

---

Author:	Geordie [ Wed Apr 08, 2015 11:46 am ]
Post subject:	Re: Fitting pins into roller bearing
Pack the bearing shell with a little bit of bearing grease then fit the rollers into the race the grease will help keep everything in place

---

Author:	anza [ Wed Apr 08, 2015 11:56 am ]
Post subject:	Re: Fitting pins into roller bearing
Do you need to have all the pins on a angle so the last one goes in. I just can't get the last pin in...

---

Author:	simon k [ Wed Apr 08, 2015 12:37 pm ]
Post subject:	Re: Fitting pins into roller bearing
get a new bearing

---

Author:	Timbo [ Wed Apr 08, 2015 2:54 pm ]
Post subject:	Re: Fitting pins into roller bearing
Simon has the answer, the rollers aren't meant to be able to come out of the bearing - or go back in again - its stuffed. Tim

---

Author:	drmini in aust [ Wed Apr 08, 2015 2:55 pm ]
Post subject:	Re: Fitting pins into roller bearing
I agree with above. New bearings are cheap. [edit] the old rollers are bound to be worn out of round anyway. Check the shaft- if there are chatter marks from the rollers, bin it and buy a new kit.

---

Author:	Morbo28 [ Wed Apr 08, 2015 6:43 pm ]
Post subject:	Re: Fitting pins into roller bearing
Same - new bearing for sure.

---

Author:	anza [ Thu Apr 09, 2015 8:49 am ]
Post subject:	Re: Fitting pins into roller bearing
Thanks for all the feed back.

---

Page 1 of 1	All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/