Nice find KLAS
| ausmini https://www.ausmini.com/forums/ |
|
| MEMS Diag https://www.ausmini.com/forums/viewtopic.php?f=2&t=89647 |
Page 1 of 1 |
| Author: | KLAS [ Sun Jun 07, 2015 6:14 pm ] |
| Post subject: | MEMS Diag |
just found this http://memsdiag.blogspot.de/ maybe helpfull for some of you. i tried the lite version, and it works with my MEMS 1.6 test bench, but not with MEMS 1.3. thats no surprise as the software only supports MEMS 1.6 and 1.9. will get an adapter for MEMS 1.9 soon and test is, too |
|
| Author: | 9YaTaH [ Mon Jun 08, 2015 11:54 am ] |
| Post subject: | Re: MEMS Diag |
Nice find KLAS
|
|
| Author: | KLAS [ Wed Jun 10, 2015 12:33 am ] |
| Post subject: | Re: MEMS Diag |
got a cheap KKL interface to connect to the OBD connector used on later cars. it works, too. not always on the first try, but if you keep touching "connect" it finally will connect and run ok. got in contact with the developer and he will have a look regarding MEMS 1.3. not the most common ECU, but always nice to have it included. and i'm hoping for a bluetooth version |
|
| Author: | 9YaTaH [ Wed Jun 10, 2015 10:15 am ] |
| Post subject: | Re: MEMS Diag |
Bluetooth? Remapping whilst on the Autobahn...love it! |
|
| Author: | KLAS [ Wed Jun 10, 2015 4:20 pm ] |
| Post subject: | Re: MEMS Diag |
sadly true remapping is not possible due to ECU design. but you can adjust a bit. or log the data to check for an intermittent failure |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|