Will give it a go by the book, and see what happens
| ausmini https://www.ausmini.com/forums/ |
|
| Timing question https://www.ausmini.com/forums/viewtopic.php?f=2&t=89812 |
Page 1 of 1 |
| Author: | mooman10_0 [ Fri Jun 26, 2015 8:09 am ] |
| Post subject: | Timing question |
Hi guys , I am getting close to reinstalling my engine into my Moke. I have had distributer out, head off (converted to unleaded). New timing chain. Is there a way while out that I can roughly get it timed before it goes in so that it will be close? Timingchain installed correctly, have made timing marks clearly visible on flywheel, new points fitted aswell as cap/ leads. Cheers, Mooman |
|
| Author: | gtogreen1969 [ Fri Jun 26, 2015 8:49 am ] |
| Post subject: | Re: Timing question |
As long as your points are just cracking open at TDC or just before TDC it will fire up and run fine. |
|
| Author: | 1018cc [ Fri Jun 26, 2015 3:14 pm ] |
| Post subject: | Re: Timing question |
You could always statically time it to what a workshop manual says for your car and it should be more than good enough to get you running. |
|
| Author: | mooman10_0 [ Fri Jun 26, 2015 3:20 pm ] |
| Post subject: | Re: Timing question |
Will give it a go by the book, and see what happens
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|