Does anyone know of a retailer that sells the original type of clutch release bearing for Minis - the type that has a large flat thrust face rather than just the thin edge of an outer bearing shell.

_________________
Curly
'64 Cooper 'S' (Group Nb spec)
'67 Mini Marcos GT www.mm7056.wordpress.com

I still have a few, $90 posted. If you are interested PM me. Can't promise speedy delivery though as they aren't stored at my place, so i would need to pick them up.

Otherwise i saw heritage MG had some as well as minisport, but they may be out of stock.

link had some

_________________
65 panel van Sprog
73 panel van Iggy

Simon_k had a few as well.

_________________
the world is a book, and those who do not travel read only a page
66 Mini Minor sponsored by http://www.lifeonthehedge.com.au/ The Dog Harness Specialists
It was a pleasure ausmini. I'll miss all you misfits and reprobates

long time ago...

Matt probably has the last ones in captivity

_________________
did I tell you that I won a trophy?

lucky i got a couple from you then!

_________________
the world is a book, and those who do not travel read only a page
66 Mini Minor sponsored by http://www.lifeonthehedge.com.au/ The Dog Harness Specialists
It was a pleasure ausmini. I'll miss all you misfits and reprobates

shame I didn't keep any for myself

_________________
did I tell you that I won a trophy?

Glad I got one off you! Engine build coming up soon.

_________________
Flute - 68 MK I Cooper S
Member: VMCI #2474
Member: International Mini Model Collectors Club

Heritage. Mg in Sydney stock them
Circa $90

For those that may have been interested, my stock is now all sold out