ausmini
https://www.ausmini.com/forums/

Water Pump Pulley
https://www.ausmini.com/forums/viewtopic.php?f=2&t=90742		 Page 1 of 1
Author:  jpodge [ Wed Oct 07, 2015 6:18 pm ]
Post subject:  Water Pump Pulley
Hi All!

I'm chasing the dimensions of the bolt pattern of the water pump pulley. I don't have one that I can measure with the verniers and I wont have access to my car for a few weeks. I'm looking to machine one of the up-sized pulleys not only to maintain my lathe qualification at uni but as well as $150 from minisport for a bloody pulley can stick it.
If anyone has a CAD drawing or anything that'd help me out so I could make one up that'd be greatly appreciated. I'll see if I could make a few and mayyyyyyybe give away some!
Thanks!
Joe
Author:  simon k [ Wed Oct 07, 2015 9:16 pm ]
Post subject:  Re: Water Pump Pulley
PM sent ;)
Author:  gtogreen1969 [ Wed Oct 07, 2015 9:48 pm ]
Post subject:  Re: Water Pump Pulley
Only $25 on ebay. http://www.ebay.com.au/itm/MINI-COOPER- ... 3d054497f1
Author:  jpodge [ Fri Oct 09, 2015 6:37 am ]
Post subject:  Re: Water Pump Pulley
gtogreen1969 wrote:
Only $25 on ebay. http://www.ebay.com.au/itm/MINI-COOPER- ... 3d054497f1


Fantastic! Thanks a lot for showing me that. I just purchased one and I'll get around to practice making them up on the lathe.

Simon, I'll get back to you mate! Cheers
Author:  Convertible Mini [ Sat Oct 10, 2015 6:55 am ]
Post subject:  Re: Water Pump Pulley
Good work.
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/