Hi All!

I'm chasing the dimensions of the bolt pattern of the water pump pulley. I don't have one that I can measure with the verniers and I wont have access to my car for a few weeks. I'm looking to machine one of the up-sized pulleys not only to maintain my lathe qualification at uni but as well as $150 from minisport for a bloody pulley can stick it.
If anyone has a CAD drawing or anything that'd help me out so I could make one up that'd be greatly appreciated. I'll see if I could make a few and mayyyyyyybe give away some!
Thanks!
Joe

_________________
-----Better is the enemy of good-----
-1976 Yellow Devil Leyland Clubman-
-1970 Morris Mini Van - Work in progress-

PM sent

_________________
did I tell you that I won a trophy?

Only $25 on ebay. http://www.ebay.com.au/itm/MINI-COOPER- ... 3d054497f1

Fantastic! Thanks a lot for showing me that. I just purchased one and I'll get around to practice making them up on the lathe.

Simon, I'll get back to you mate! Cheers

_________________
-----Better is the enemy of good-----
-1976 Yellow Devil Leyland Clubman-
-1970 Morris Mini Van - Work in progress-

Good work.

_________________
DID I MENTION THAT I AM THE BEST SUPPLIER FOR MINI ELECTRICAL PARTS AND REPAIRS?
"Let us remove your "SHORTS"