ausmini https://www.ausmini.com/forums/
New wiring qu https://www.ausmini.com/forums/viewtopic.php?f=2&t=90814	Page 1 of 1

---

Author:	mooman10_0 [ Sun Oct 18, 2015 10:43 am ]
Post subject:	New wiring qu
Hi everyone, Ihave just fitted new loom to my Moke project, all lights working with test but am having issues like when pressing horn , dash lights flash, heater switch sets of wiper motor, lol. I'm guessing I have put earth in wrong spot? I fitted earths to a bolt on the back of speedo where they previously were? Any thoughts, all items in good working order seperately, is a new loom from vinwire. Trying to get all dash stuff sorted before I fire it. Thanks, Steve

---

Author:	mooman10_0 [ Sun Oct 18, 2015 1:12 pm ]
Post subject:	Re: New wiring qu
All sorted, traced it to a dodgy fuse box, switched for new one and everything works perfectly

---

Author:	mooman10_0 [ Sun Oct 25, 2015 12:04 pm ]
Post subject:	Re: New wiring qu
So after ALOT of tinkering i have a wiring system where everything works!!! The flasher staying on was just the flasher unit itself and a new quality one worted it. I still had some intermittent faults with dash panel lights, turned out that the earth was not strong enough attached to the rear of the speedo pod, I left taht earth there but ran another one to the body of the car and whamo it all works perfectly . Finally a happy chappy! Even turned the key with a little fuel down the bowl and it fired first go ( no exhaust on her yet), so looks like completion isnt too far away!

---

Author:	Mick [ Sun Oct 25, 2015 12:15 pm ]
Post subject:	Re: New wiring qu
Well done Mooman. I'm sorry no one else could help, but be buggered if I could think of any one thing to sort all that out. Although nearly always incorrect, it seems that bad earths really was your problem!

---

Page 1 of 1	All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/