| ausmini https://www.ausmini.com/forums/ |
|
| 7 port alloy head https://www.ausmini.com/forums/viewtopic.php?f=2&t=90932 |
Page 1 of 1 |
| Author: | Minicooper70 [ Sun Nov 01, 2015 1:50 pm ] |
| Post subject: | 7 port alloy head |
just pulled my head off for a tidy up and new gasket. just wondering whose running these heads and what tension should be used for head studs and gap for roller rockers |
|
| Author: | drmini in aust [ Sun Nov 01, 2015 3:32 pm ] |
| Post subject: | Re: 7 port alloy head |
I've heard to keep head tension below 35 ft/lb or the alloy collapses... re the roller rockers, 1.3:1 ratio, use normal clearance (whatever the cam maker recommends), often it's .016" 1.5:1 ratio, add .003" to above. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|