| ausmini https://www.ausmini.com/forums/ |
|
| distributor question https://www.ausmini.com/forums/viewtopic.php?f=2&t=90977 |
Page 1 of 1 |
| Author: | mooman10_0 [ Sat Nov 07, 2015 11:18 am ] |
| Post subject: | distributor question |
Hi guys and girls, I am having distributor issues, had been sitting 20 yrs and when I went to change points the thread for the screw is totall stuffed for the body of the distributor. The whole thing looks like it has seen better days. Qu is I see minisport sell a complete distributor with cap, rotor ect for $115 new. It is the same as mine except mine dosent have a vacuum advance. Will this still work and I just hook the vacuum advance up to the carb where it is blocked off? Cheers, Steve |
|
| Author: | Mick [ Sat Nov 07, 2015 12:00 pm ] |
| Post subject: | Re: distributor question |
Yes your dizzy can be replaced as a whole, only thing to watch is that the advance curve is specific for your engine. Again, this is quite easy if your engine is a more or less low tune (stock) configuration. Dizzies are available in most of the original styles. Look at Accuspark or Powerspark Ignition |
|
| Author: | mooman10_0 [ Sat Nov 07, 2015 12:15 pm ] |
| Post subject: | Re: distributor question |
Awesome , just ordered a stock replacement with vacuum advance and the hose to go with it. Cheers, Steve |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|