Karcraft told me there are 2 types. Standard and Cooper S. I believe the S is a different design......so that's probably the difference you have seen
| ausmini https://www.ausmini.com/forums/ |
|
| Clutch release Bearing https://www.ausmini.com/forums/viewtopic.php?f=2&t=9125 |
Page 1 of 1 |
| Author: | aaron [ Sat Jul 16, 2005 9:28 pm ] |
| Post subject: | Clutch release Bearing |
I know this may be a stupid question but is there a difference in release bearings form an 1100 to a 1275. My thought is not, but when i think back to when i installed the clutch cover i noticed that it was thinner on the 1100. Anyone? Cheers Aaron |
|
| Author: | J_A_M [ Sat Jul 16, 2005 9:34 pm ] |
| Post subject: | |
Karcraft told me there are 2 types. Standard and Cooper S. I believe the S is a different design......so that's probably the difference you have seen
|
|
| Author: | aaron [ Sat Jul 16, 2005 9:37 pm ] |
| Post subject: | |
i bought a new one, but did i bother to put it in. nooooo, or course not..... i guess i should change it. just in case i have no clutch.... that would suck! 
Cheers Aaron |
|
| Author: | drmini in aust [ Sat Jul 16, 2005 11:35 pm ] |
| Post subject: | |
There are 2 types I know of- early flat type (for the old coil spring clutches) and the later one with the ridge round it (for diaphragm clutches). The later ones are either made by RHP in UK (good) or are a Jap bearing- JTN? (a POS). One of the latter I trashed in 3 days.  You DO get what you pay for...
I won't buy them now unless they say `Made in England'. 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|