Ausmini
It is currently Sat Jul 19, 2025 2:25 am

Board index » Mini Chat » Mini Chat

All times are UTC + 10 hours




Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 
  Print view Previous topic | Next topic 
Author Message
JimL
PostPosted: Wed Dec 30, 2015 11:34 am 
Offline
848cc
848cc

Joined: Sat Aug 27, 2011 9:34 pm
Posts: 307
Location: East Melbourne
Has anyone found a good quality hex head alternative to the socket head nuts supplied with JBW Wheels?
The nuts that came with the Mambas always seem to get stuck on the hex bit that was supplied with them and are starting to get a little flogged out.
I use a torque wrench set to about 60Nm so I don't think it is a case over-tightening.
Cheers
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 

Board index » Mini Chat » Mini Chat

All times are UTC + 10 hours


Who is online

Users browsing this forum: No registered users and 95 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  

© 2016 Ausmini. All garage work involves equal measures of enthusiasm, ingenuity and a fair degree of irresponsibility.