| ausmini https://www.ausmini.com/forums/ |
|
| HS2 Carb Float Bowl Lug https://www.ausmini.com/forums/viewtopic.php?f=2&t=91610 |
Page 1 of 1 |
| Author: | GundyGuy [ Fri Jan 22, 2016 5:05 pm ] |
| Post subject: | HS2 Carb Float Bowl Lug |
Just wondering if anyone has successfully fixed a broken Float Bowl Position Lug This is the little lug on the carb body that the rubber grommet locates in to position the float chamber I was thinking of tapping a small thread and fitting a small screw All input appreciated |
|
| Author: | Goldbrocade_62 [ Fri Jan 22, 2016 5:57 pm ] |
| Post subject: | Re: HS2 Carb Float Bowl Lug |
I have drilled them before and used a rollpin |
|
| Author: | GundyGuy [ Fri Jan 22, 2016 6:20 pm ] |
| Post subject: | Re: HS2 Carb Float Bowl Lug |
Sounds like a plan |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|