| ausmini https://www.ausmini.com/forums/ |
|
| Chassis number https://www.ausmini.com/forums/viewtopic.php?f=2&t=92510 |
Page 1 of 1 |
| Author: | Coops69 [ Thu Apr 28, 2016 9:41 pm ] |
| Post subject: | Chassis number |
Hey guys, I have a question to throw out to you: The chassis number on my Mini is unfortunately rubbed out, you can only make out some of the numbers. What would you suggest to use / do in order to bring the full chassis number out again? Many thanks. [THUMBS UP SIGN] |
|
| Author: | Dan69s [ Thu Apr 28, 2016 10:04 pm ] |
| Post subject: | Re: Chassis number |
Heat with a oxy or similar, remove the paint with a wire brush. Then heat up the numbers until you can read what they say. It's like a tattoo, you can still read them when there heated although you can't when it's cold. Good luck Daniel |
|
| Author: | gtogreen1969 [ Thu Apr 28, 2016 10:14 pm ] |
| Post subject: | Re: Chassis number |
That's a bugger. I have seen so many cars that have been butchered and given a new chassis number. Is yours restamped with a NxxxxxP number? I used battery acid and wet and dry sandpaper on my engine block but I haven't tried it on a body number. If yours is a 1969 car you should also have a number stamped into the drain gutter above your wiper motor. 2/06 and a 3 digit number . Like this 
|
|
| Author: | Coops69 [ Fri Apr 29, 2016 1:00 pm ] |
| Post subject: | Re: Chassis number |
Cheers - I'll have a look next week when I'm back home. I'm pretty sure it's a 69 model. Sent from my iPhone using Tapatalk |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|