| ausmini https://www.ausmini.com/forums/ |
|
| popped knuckle joints https://www.ausmini.com/forums/viewtopic.php?f=2&t=92863 |
Page 1 of 1 |
| Author: | dimmo [ Sat Jun 11, 2016 1:19 pm ] |
| Post subject: | popped knuckle joints |
Hi, Recently reinstalled the rear subframe and trailing arms and shockers etc and left car on rear wheels with a spit attached to the front. Moved it several times around shed and bounced on the shockers a few times. now i find the knuckle joints have popped out. what is supposed to stop this happening ie just the shocker. I used the old trumpet with new cones and knuckles and rebuilt trailing arms. Any suggestions or ideas. All help appreciated Regards Graeme |
|
| Author: | fuzzy-hair-man [ Sat Jun 11, 2016 2:28 pm ] |
| Post subject: | Re: popped knuckle joints |
The shock stops the trailing arm from dropping too far down and pulling out of the joint / rubber cone / trumpet etc |
|
| Author: | peterb [ Sat Jun 11, 2016 3:50 pm ] |
| Post subject: | Re: popped knuckle joints |
Isnt there long and short shocks? |
|
| Author: | dimmo [ Sat Jun 11, 2016 4:54 pm ] |
| Post subject: | Re: popped knuckle joints |
Just had a better look and it seems the rubber dust seals have pulled off the cup rather than the ball pulled out |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|