Thankyou
| ausmini https://www.ausmini.com/forums/ |
|
| Cast iron welding https://www.ausmini.com/forums/viewtopic.php?f=2&t=92864 |
Page 1 of 1 |
| Author: | Ian_B [ Sat Jun 11, 2016 2:15 pm ] |
| Post subject: | Cast iron welding |
I have a block that has suffered damage to one of the locating stud holes to gearbox. Accident damage. It needs a copper round insert to be made to weld with what I think are these gemini 98 welding rod for cast iron. There is still half a hole there .Should I even bother. Thanks Ian |
|
| Author: | peterb [ Sat Jun 11, 2016 4:02 pm ] |
| Post subject: | Re: Cast iron welding |
Can you drill and tap it further in? |
|
| Author: | drmini in aust [ Sat Jun 11, 2016 5:24 pm ] |
| Post subject: | Re: Cast iron welding |
I would weld the boss up solid with castcraft 100 (100% nickel) electrode then re-machine the hole on the mill. The nickel deposit is fully machinable. |
|
| Author: | Ian_B [ Sun Jun 12, 2016 10:26 am ] |
| Post subject: | Re: Cast iron welding |
Thankyou |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|