ausmini https://www.ausmini.com/forums/ |
|
Cone removal tool Newcastle https://www.ausmini.com/forums/viewtopic.php?f=2&t=93438 |
Page 1 of 1 |
Author: | bluehishouse [ Sun Aug 14, 2016 3:55 pm ] |
Post subject: | Cone removal tool Newcastle |
Ive read a bit about it and could knock one up but my time outside of work is pretty limited for shopping, so does anyone in newcastle have a cone compressor i could borrow? Payment in beer, weekend car work or love. Cheers Nic Sent from my SM-G900I using Tapatalk |
Author: | TheMiniMan [ Mon Aug 15, 2016 2:16 pm ] |
Post subject: | Re: Cone removal tool Newcastle |
just remove the top control arm completely you won`t need the spring-compressing tool fit hi-lo adjuster struts back in & again , no need for compressing tool re-new the control arm bearings & pin & seals while you`re there check the 'seat" inside the top arm for the cone shaped seat that needs to still be cone-shaped for the new nylon cup to seat correctly if you fit a new nylon cup into a worn arm it will distort quite quickly & you will have problems Matt |
Author: | oldblade [ Mon Aug 15, 2016 6:37 pm ] |
Post subject: | Re: Cone removal tool Newcastle |
How hard is it to remove the top arm? I'd like to replace all my bushes and rubbers in the front end and haven't attacked the suspension yet |
Author: | bluehishouse [ Mon Aug 15, 2016 9:02 pm ] |
Post subject: | Re: Cone removal tool Newcastle |
not doing hi-lows and i was thinking of putting new cones in but wasn't sure. never had the suspension out so dunno what to expect, just don't want to get half the job done. |
Author: | Phil 850 [ Mon Aug 15, 2016 9:22 pm ] |
Post subject: | Re: Cone removal tool Newcastle |
This is how I did it viewtopic.php?f=2&t=91132 |
Page 1 of 1 | All times are UTC + 10 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |