| ausmini https://www.ausmini.com/forums/ |
|
| M35 starter motor pinion assembly https://www.ausmini.com/forums/viewtopic.php?f=2&t=93630 |
Page 1 of 1 |
| Author: | deluxe67 [ Thu Sep 01, 2016 10:09 am ] |
| Post subject: | M35 starter motor pinion assembly |
Today I'm going to install a 2nd hand pinion from Oz on a mates starter motor here in Bali. I didn't bring my workshop manual with me and for the life of me I can't remember if the pinion should be assembled dry or with antiseize/ oil? Can someone enlighten me please. I hope the ring gear is not too chewed up... Thanks Michael |
|
| Author: | drmini in aust [ Thu Sep 01, 2016 11:44 am ] |
| Post subject: | Re: M35 starter motor pinion assembly |
Put the pinion assembly on the shaft, then lubricate the bendix spline with graphite powder. |
|
| Author: | deluxe67 [ Thu Sep 01, 2016 12:29 pm ] |
| Post subject: | Re: M35 starter motor pinion assembly |
Thanks Doc will do, if I can find some... |
|
| Author: | simon k [ Thu Sep 01, 2016 1:58 pm ] |
| Post subject: | Re: M35 starter motor pinion assembly |
if you can't find some, just scribble a HB pencil on some emery paper and wipe it on - same stuff |
|
| Author: | Convertible Mini [ Thu Sep 01, 2016 6:01 pm ] |
| Post subject: | Re: M35 starter motor pinion assembly |
Or just clean and dry the shaft. No lube required. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|