Do they have one between the plate and arm ....can't for the life of me remember .
Just reassembling now so can make one if needed ...

Also the handbrake quadrant has nylon washers top and bottom right ?
Any one with a pic of the types of washer and clips to use ?

Many thanks !


Sent from my iPad using Tapatalk

_________________
Simonw
Brisbane QLD
1st car - 1964 Mini Panelvan 850
Previous - 1978 Leyland LS 1275 Gold
- 1969 Mini K

Have you tried the likes of Mini spares UK on their parts catalogues. The exploded diagrams are great for showing the assembly order and what's actually fitted where.

Not shown in Mini King catalog. I pulled a backplate off a GT this week and there was none there.
There is a paper gasket behind the rear brake cylinder, but most people leave it out.

_________________
DrMini- 1970 wasaMatic 1360, Mk1S crank, 86.6HP (ATW) =~125 @ crank, 45 Dellorto (38 chokes), RE282 sprint cam, 1.5 rockers, 11.0:1 C/R.

1. I've never seen a gasket between backing plate and swing arm.
2. The handbrake quadrant has only 1 nylon washer (21A1512) fitted to the top side - none underneath. The flat, coil spring washer (2K2545); followed by the spire clip (21A1513).
3. The parts diagrams show the coil spring fitted FIRST and the nylon washer next. Is this right? The nylon washer looks like it should go on first - partly as a dust seal.

Thanks guys!
@bill yes I was equally confused at the diagram too...


Sent from my iPad using Tapatalk

_________________
Simonw
Brisbane QLD
1st car - 1964 Mini Panelvan 850
Previous - 1978 Leyland LS 1275 Gold
- 1969 Mini K

Sent from my iPad using Tapatalk

_________________
Simonw
Brisbane QLD
1st car - 1964 Mini Panelvan 850
Previous - 1978 Leyland LS 1275 Gold
- 1969 Mini K