Hello I was wondering if anyone can tell if there is problems with bolting a MPI head onto a series (pre a+) 1275? Thanks Scott


Sent from my iPad using Tapatalk

Shouldnt be any they were the same as everything else.
Its the mpi blocks that are different cause they dont have a distributor.

. Thanks, the CC is the same size, it all looks straight forward, I am assuming manifolds will bold straight up


Sent from my iPad using Tapatalk

Crikey, if you put a MPI head on it, you'll have to get it re-engineered as a new car.

I have an MPI head on a 1275. It did not have fittings for the standard temp sender, bypass hose and heater outlet.
It may not be a problem for your application, and some MPI heads may have these fittings.

Ta, doesn't sound too scared


Sent from my iPad using Tapatalk

. I know, it will create expectations of fancy injection stuff


Sent from my iPad using Tapatalk