ausmini https://www.ausmini.com/forums/ |
|
Service Bulletin PRIMARY GEAR https://www.ausmini.com/forums/viewtopic.php?f=2&t=95314 |
Page 1 of 1 |
Author: | ALPINE MOKE [ Mon May 01, 2017 8:47 am ] |
Post subject: | Service Bulletin PRIMARY GEAR |
I am looking for a UK Primary Gear Service Bulletin No GN/92 it was published about 1961 2-3. It may not have been published in Australia. |
Author: | drmini in aust [ Mon May 01, 2017 9:32 am ] |
Post subject: | Re: Service Bulletin PRIMARY GEAR |
Is that the one about converting the early wet tail crank to take the later dry type primary gear? |
Author: | ALPINE MOKE [ Mon May 01, 2017 12:01 pm ] |
Post subject: | Re: Service Bulletin PRIMARY GEAR |
Correct Dr Mini |
Author: | drmini in aust [ Mon May 01, 2017 12:23 pm ] |
Post subject: | Re: Service Bulletin PRIMARY GEAR |
Don't have copy but I remember it involved punching a .080"? diameter brass plug in when I did it. |
Author: | ALPINE MOKE [ Mon May 01, 2017 12:31 pm ] |
Post subject: | Re: Service Bulletin PRIMARY GEAR |
Thanks for the Info. Les |
Author: | winabbey [ Mon May 01, 2017 1:00 pm ] |
Post subject: | Re: Service Bulletin PRIMARY GEAR |
Service Bulletin GN/92 was issued by BMC UK. The equivalent BMC Australia Bulletin is C236 (see below). Is this what you are after? Attachment: C 236_63 p1.jpg Attachment: C 236_63 p2.jpg Attachment: C 236_63 p3.jpg Attachment: C 236_63 p4.jpg
|
Author: | ALPINE MOKE [ Mon May 01, 2017 2:43 pm ] |
Post subject: | Re: Service Bulletin PRIMARY GEAR |
Thank you for the Info, its what I was after. Thanks again. Les |
Author: | gtogreen1969 [ Mon May 01, 2017 4:08 pm ] |
Post subject: | Re: Service Bulletin PRIMARY GEAR |
Your a champion Doug |
Page 1 of 1 | All times are UTC + 10 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |