| ausmini https://www.ausmini.com/forums/ |
|
| thread size first motion shaft size wanted https://www.ausmini.com/forums/viewtopic.php?f=2&t=95711 |
Page 1 of 1 |
| Author: | kiwiinwgtn [ Sun Jul 09, 2017 5:38 pm ] |
| Post subject: | thread size first motion shaft size wanted |
Hi would any on know what size the thread is on the first motion shaft. It looks like its 13/16 20 tpi just want to be sure Thanks Kiwiinwgtn |
|
| Author: | drmini in aust [ Sun Jul 09, 2017 5:41 pm ] |
| Post subject: | Re: thread size first motion shaft size wanted |
I will measure in the morning. |
|
| Author: | Bill B [ Sun Jul 09, 2017 9:23 pm ] |
| Post subject: | Re: thread size first motion shaft size wanted |
Yes. I measured 0.808 inch (allowing for wear) = 13/16 x 20 tpi is a UNEF thread (extra fine). |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|