So I've started assembling bits on my engine. All the new rod bearings all have cracks here where the tang is. Is this normal or are these bin fodder?
| ausmini https://www.ausmini.com/forums/ |
|
| Rod Bearings https://www.ausmini.com/forums/viewtopic.php?f=2&t=95783 |
Page 1 of 1 |
| Author: | timmy201 [ Sun Jul 23, 2017 3:15 pm ] |
| Post subject: | Rod Bearings |
So I've started assembling bits on my engine. All the new rod bearings all have cracks here where the tang is. Is this normal or are these bin fodder?
|
|
| Author: | minimans [ Sun Jul 23, 2017 3:54 pm ] |
| Post subject: | Re: Rod Bearings |
I'd trash them. I hate county stuff it's seems I always have problems with there stuff. Find some different manufacturer. |
|
| Author: | timmy201 [ Sun Jul 23, 2017 5:01 pm ] |
| Post subject: | Re: Rod Bearings |
They came in a "King Bearings" box so I was surprised they were County inside.. |
|
| Author: | drmini in aust [ Sun Jul 23, 2017 6:23 pm ] |
| Post subject: | Re: Rod Bearings |
King bearings own county. Buy the King HD ones. Or ACL HD which are available again. |
|
| Author: | timmy201 [ Sun Jul 23, 2017 8:39 pm ] |
| Post subject: | Re: Rod Bearings |
The ones I bought had HD at the end of the part number, (8G2198HD 030) I though they were they good ones.. |
|
| Author: | drmini in aust [ Sun Jul 23, 2017 10:40 pm ] |
| Post subject: | Re: Rod Bearings |
Well, they are better than the ones I got by an ordering mistake on my part, std County aluminium tin ones in a King box. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|