ausmini
https://www.ausmini.com/forums/

Dimensions Dimensions Dimensions
https://www.ausmini.com/forums/viewtopic.php?f=2&t=96258		 Page 1 of 1
Author:  Besser [ Thu Nov 02, 2017 12:31 pm ]
Post subject:  Dimensions Dimensions Dimensions
New Project Car in the shed a couple of weeks ago and I'm looking at a front end build/repair. Tradition says, use new panels and gaps to state dimensions yet, with the amount of jogging the shell's had and the high inaccuracy of replacement panels I'm here looking for some quality specifications. :D

So where or who can I cajole to get some detailed reference dimensions.

EG: height of bonnet at front corners, curve specs for front valance??? does any of this exist in the public arena?
Author:  Besser [ Mon Nov 06, 2017 6:19 pm ]
Post subject:  Re: Dimensions Dimensions Dimensions
Anyone?
Author:  michaelb [ Mon Nov 06, 2017 7:21 pm ]
Post subject:  Re: Dimensions Dimensions Dimensions
Hi Bessel,
I’m not sure there are any specific measurements available for the dimensions you are asking about. From past experience I find it is all about how the panels look when they line up and years of experience at owning minis and looking at other cars to see how their panels line up. I have spent many hours fitting ne guards and front valance to line up with the bonnet with equal and minimal gaps all around and then after paining and fitting the bonnet latch and rubber buffers the bonnet no longer fits snug :?
I would try and find a few other minis to look at and take measurements to help answer your questions.
Author:  p7676 [ Mon Nov 06, 2017 9:42 pm ]
Post subject:  Re: Dimensions Dimensions Dimensions
give it a miss get an expert to do it
p7676
Author:  winabbey [ Mon Nov 06, 2017 10:39 pm ]
Post subject:  Re: Dimensions Dimensions Dimensions
Have a look at the alignment section in the workshop manual here - http://www.ausmini.com/manuals/Mini%20W ... 20Body.pdf
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/