| ausmini https://www.ausmini.com/forums/ |
|
| engine subframe installation 1970 CS https://www.ausmini.com/forums/viewtopic.php?f=2&t=96296 |
Page 1 of 1 |
| Author: | p7676 [ Sat Nov 11, 2017 4:41 pm ] |
| Post subject: | engine subframe installation 1970 CS |
I am fitting the engine to the subframe out of the car, can I fit the carbies ? I am lifting the body over the engine and subframe, also are there any other problems which may arise ? Thanks P7676 |
|
| Author: | JimL [ Sat Nov 11, 2017 4:51 pm ] |
| Post subject: | Re: engine subframe installation 1970 CS |
No you probably wont be able to fit the carbies. it is also much easier to drop the engine in from the top with the subframe already installed to the body. |
|
| Author: | simon k [ Sat Nov 11, 2017 5:30 pm ] |
| Post subject: | Re: engine subframe installation 1970 CS |
I've fitted the engine and subframe as a unit a few times, don't have any trouble with it... but no, can't do it with the carbs fitted, they hang over the crossmember when installed. |
|
| Author: | 1071 S [ Sun Nov 12, 2017 1:24 pm ] |
| Post subject: | Re: engine subframe installation 1970 CS |
I'm with JimL.... But be very careful with the exhaust manifold. Some ( including the original S manifold) can be almost impossible to fit once the engine is bolted into the subframe - whether or not the subframe is attached to the car... Having been caught out, I tie the manifold roughly in place with some thin rope before dropping it into the subframe. Cheers, Ian |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|