ausmini https://www.ausmini.com/forums/ |
|
Vtec frame again https://www.ausmini.com/forums/viewtopic.php?f=23&t=100810 |
Page 1 of 1 |
Author: | STABBA [ Thu Mar 04, 2021 5:10 pm ] |
Post subject: | Vtec frame again |
Hi guys I have a project I have gotten into and I’ve decided to go the vtec route organised engineer have spoken with all speed and liased with engineer who agrees this is the best route my question is however how do I pay customs duty bla bla do I just order frame and pay for it or do I have to get some kind of form sorry for the noob question |
Author: | simon k [ Thu Mar 04, 2021 6:34 pm ] |
Post subject: | Re: Vtec frame again |
Just order it, the freight company contacts you to out payable customs/GST etc. when it arrives in Aust and before they forward it on to you. VTEC by the way, no "H" |
Author: | STABBA [ Fri Mar 05, 2021 11:45 am ] |
Post subject: | Re: Vtec frame again |
Thanks mate order done and spelling corrected |
Author: | Sreedon [ Sat Mar 06, 2021 7:15 pm ] |
Post subject: | Re: Vtec frame again |
I’d love a Vtec mini, hope you post the whole conversion project here. Good luck with the engineering and rego challenge. Cheers, Si... |
Author: | STABBA [ Thu Mar 18, 2021 8:01 pm ] |
Post subject: | Re: Vtec frame again |
So hard to find a b16 vtec feeling pretty old |
Author: | Harley [ Fri Mar 19, 2021 12:17 pm ] |
Post subject: | Re: Vtec frame again |
Could always do a D16 - they're cheap and plentiful. I'm doing a D16 VTEC at the moment - they aren't that much less powerful than the B16s, and they're smaller and lighter too so the car should drive and handle better. |
Author: | simon k [ Fri Mar 19, 2021 8:10 pm ] |
Post subject: | Re: Vtec frame again |
I drove past a local performance workshop today and there was a mini with a K series in it sitting out the front. Race car though.. |
Author: | Dutchy1978 [ Sun Mar 28, 2021 10:34 pm ] |
Post subject: | Re: Vtec frame again |
Good luck with the build. As long as you don’t expect the frame to be the only requirement and are prepared to do a lot of modifications then you should be fine. Keep us updated. |
Author: | STABBA [ Wed Mar 31, 2021 5:09 pm ] |
Post subject: | Re: Vtec frame again |
Thanks mate I had a round nose with 4efte but wanted na this time pretty pumped to get stuck in got a steal on a front end 93 crx |
Page 1 of 1 | All times are UTC + 10 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |